Choose a layout and enter the spans, stiffness and loads: the tool instantly calculates support reactions, bending moments, shear forces, deflections and rotations, and plots their diagrams.

How to use it

  • The layouts offered are starting points: the number of spans, end conditions and overhangs can all be changed.
  • Several loads can be combined freely: uniform or linearly varying (trapezoidal) distributed loads, point loads and moments.
  • The stiffness EI is defined by a material and a second moment of area, entered directly or taken from an IPE, HEA or HEB section; the self-weight of the section can be added.
  • Hover over or tap the diagrams to read the shear force, moment and deflection at any point.

Assumptions

  • Straight beam with constant stiffness EI, linear elasticity and small displacements (Euler-Bernoulli theory, shear deformation neglected).
  • Rigid point supports; no axial force or second-order effects.
  • Beam finite element analysis on a fine mesh aligned with supports and loads: reactions, internal forces and nodal deflections are exact under these assumptions; checked against some forty cases from strength of materials handbooks.
  • Conventions: loads positive downwards, moments positive clockwise, bending moment positive when the bottom fibre is in tension, deflection positive downwards.
  • Unfactored loads: load combinations (ULS, SLS) and resistance checks remain to be carried out according to the Eurocodes.

Example

Two-span continuous beam with 6 m spans, IPE 300, under a uniform load of 10 kN/m.

q = 10 kN/m6 m6 mShear force V (kN)37.5-37.5Bending moment M (kN·m) — drawn on the tension side25.3-45Deflection (mm) — downwards4
Layout and diagrams calculated by the tool.
Central support
75 kN
Support moment
−45.0 kN·m
Span moment
25.3 kN·m
Deflection
4.0 mm

These are the handbook values: 10qL/8, −qL²/8, 9qL²/128 and qL⁴/(185·EI). On two simple supports, the same span would give 45 kN·m and 9.6 mm: continuity divides the deflection by 2.4.

Load this example into the tool

Method, limits and references

Euler-Bernoulli beam finite elements (about 400 elements, nodes on supports and loads); internal forces by statics, hence exact for the model; deflections and rotations exact at nodes; mechanisms detected.

Limits

  • Constant stiffness EI (or by segments from the handbook), rigid point supports.
  • No axial force, no second-order effects, no shear deformation.
  • Fixed, unfactored loads: combinations and section checks remain to be done.

References: handbook: continuous beams; EN 1990 for combinations.

Checks: 40 handbook values, maximum difference 0.006%.

Frequently asked questions

Are the loads factored?

No. Since the calculation is linear, you can enter factored loads (1.35 G + 1.5 Q) for ULS forces, or characteristic loads for deflections.

How do I add self-weight?

For an IPE, HEA or HEB, tick “Add the self-weight of the section”; otherwise, add a distributed load equal to the weight per metre.

Can I study variable inertia or a thermal gradient?

Yes: the gradient is entered below the loads; variable inertia opens from the handbook “thermal gradient and variable inertia” cases.

See also

Preliminary design aids, provided for guidance only: they do not replace calculations prepared by an engineer. Found an error, have a suggestion? Write to us.